TV ONE C2 control

[Mr_P]

Keyspan devices seem to popup as 2 devices - but you can only connect to one. - just select the one that is connected.

Otherwise - you can connect via network I you create a TCPIP port - again check tv-one manual for port address.

Have used both methods - will try and find some notes

S

[Barret]

Keyspan devices seem to popup as 2 devices - but you can only connect to one. - just select the one that is connected.

Otherwise - you can connect via network I you create a TCPIP port - again check tv-one manual for port address.

Have used both methods - will try and find some notes

S

Hi Simon,

Thanks for your input - I haven't had the time until tonight to get back on this, your right it is simple - via the keyspan at the moment - I'll attempt it with the TCPIP at another time.

The very basic codes I've used are to change Input 1a to dvi1 is:

"F0410410082000010E7" [0d]

and to DVi2:

"F0410410082000011E8" [0d]


i'm using the TVone rs232 guide pdf which can be found here:
http://tvone.crmdesk.com/answer.aspx?aid=381&back=