Catalyst can't draw perfect squares/rectangles?

[Mr_P]

can't seem to make it do this....
however, Im using manual controls not DMX to test

Are the X, Y, and Z rotation values at 0 on the HUD?
Have you tried replicating this using manual control rather than DMX?

(16 bit = 65536, not 64000... maybe this is the problem?)

Is there any reason you are running m297? This is a custom version.

try running the release version m257 - available here:

http://homepage.mac.com/goatee/.Public/m257.dmg

password peru-

Simon

[Leif]

can't seem to make it do this....
however, Im using manual controls not DMX to test

Are the X, Y, and Z rotation values at 0 on the HUD?
Have you tried replicating this using manual control rather than DMX?

(16 bit = 65536, not 64000... maybe this is the problem?)

Is there any reason you are running m297? This is a custom version.

try running the release version m257 - available here:

http://homepage.mac.com/goatee/.Public/m257.dmg

password peru-

Simon

HUD controls are indeed at 0.
I'm aware that 16bit is more than 65k steps. I was just making a point.
And no, I haven't tried to replicate with manual controls. But I will take a screen shot and upload it so you can see what is happening.

I'm running m297 because Richard sent me that version this spring... As I understand it, the public release that followed m297 had significant changes to the FX designer, and as I had already programmed my show it didn't make sense to change versions.