Finally a DVI- SDI converter

[jasonrudolph]

I wasn't much for fibre until began reading and studying more.

I've been thinking copper and then something on another thread changed my mind. Christian makes some very good points which have started to change my point of view.

Well, the reason I say this, is that you can go EITHER way with these boxes. I use them Copper as well, but for instance, if you are in a building that is pre-wired, you can jump on the fiber line, while you could NOT use the copper, as these systems dont work with ethernet systems (even gigabit)

The Magenta boxes give you that extra ace in your pocket. And they also have the loop through on them for a local monitor like the thinklogical boxes.

[SourceChild]

...if you are in a building that is pre-wired, you can jump on the fiber line, while you could NOT use the copper...

I suppose to say this correctly, the technology is not DVI over IP but DVI over Cat5e. I have been reading and studying the protocol used on the Cat5 solutions and I have discovered that it is not even a registered internet protocol.

Simply put, The boxes use twisted pair for their own protocol. Since about 50% of the TCP/IP packets is eaten up in addressing and continuity, they make for very inefficient tools to transport the very large data volume of video.

This is stuff I have always known but after the research I have done in the past few days, I am even a bit more apprehensive of using a Copper solution.

Basically the video transporters use each twisted pair to send a different part of the signal I.E. Red, Green, Blue, and Sync. This is why they will never be able to work in a traditional network.