Solved...
Create preset(6) for 'cue6' 10s PlayLoopFW>0. (folder 001 file 001)
**HOWEVER make your content with 2 extra frames ie 252 frames.**
Set outframe to 250frames (10s)
Create a preset(8) for 'cue7' as normal (folder 001 file 002)
Create a preset(7) to change L3 outframe to 0 and playmode to PlayOnceFW>0 (just these 2 parameters)
(this is the trigger)
Create a cuelist using Layer3 as timecode source
Create Cue1 as 'PLAY' with command PresetToCuelist=6 - this enables the cuelist
Create Cue 2 as 'Preset 7' - this plays preset 8 (cue 7)
-set the time for this cue to 10s (250f) or 1 frame after the loop point
optional:
create Cue 3 fade 'layer 3' - (if required)
works like a dream!!...
The key to this is to add 2 frames on to the looping movie BUT to set the outframe to the actual desired loop time (250f)
So it the loop never reaches the end of the movie and the resulting timecode to trigger the next cue
Once 'cue 7 trigger' is triggered L3 plays to the end of the movie (+2f) and triggers the next cue 7
If you need a good x-fade - then extend the clips further and adjust the trigger timecode to compensate.
This all assumes 25fps - adjust for 30fps as necessary
See ZIP file with catalyst show (programmed on m257)
Content used:
Lib 001
File 001 - Loop 252 frames (loops at 250)
File 002 - another movie
Show & Content can be downloaded from:
http://homepage.mac.com/WebObjects/F...eSharing6.html
Do call if you need some more assistance
Simon