Assuming screen res of 1024x768...

- Go fullscreen (both)
- enable HUD (both)
- unlock mixes
- Mix 1 on output 1 - set to 1024x768, position 0,0
- Mix 2 on output 2 - set to 1024x768, position 0,0
- set layer 1 to Mix 1, Layer 2 to mix 2
- for this example - get the same bit of content on both layers.
- Ensure you can see content normally full screen (scales up if necessary)

Do the same on both mix windows:
- open mix options
- blending: edge blend ON
- for Mix 1 - belnd right ON (20%)
- for Mix 2 - blend left ON (20%)
you should see right and left edges blended

Keystone - on both mixes:
- Mix: top button, 'select keystone ON'
***the image will disappear to under the 'mix options' window***
- close the mix options window
- position the mix by the centre marker
- adjust the corners as necessary


Note - you may want to sort out your keystone first before applying blend - as the blend seems to scale with the keystone, when moving the points.... which makes sense, but you may end up with more blend than you want. - try it both ways, and you'll see what I mean....


when finished, lock mixes and turn off HUD

Good luck lining up the DL1's with keystone applied.... you're braver than me!

Simon