Is there anyway to trigger router inputs/outputs via presets?
Is there anyway to trigger router inputs/outputs via presets?
Hi,
Drag the router config into a cue list. Then in the cue number box type the following: PresetToCuelist=1
Change the number to match the preset you want to use to trigger. Cue list acts as a lookup table.
Hope this helps,
Salvador
I thought I tried that and but it wouldn't drag. I'll try it again tomorrow.
I miss spoke in my original post, I was actually talking about the Video Switcher. However, I can't get either the router or the Video Switcher to drag over to the Cuelist. I can get just about every other component on the catalyst control to, but not the Switcher and Router.
Any ideas?
Thanks,
hi, you must press ALT while dragging.
That did it, thanks!