cat v4.06 m67 beta 4

[Guy Conger]

Playing with a Triple Head 2 Go on on the latested m57 build. Setup is as follows. One DVI monitor connected to the DVI out. One Triple head to go with three monitors connected to the VGA out. Mac and catalyst recognize both screens at the correct resolution DVI at 1024x768 Triple head at 3072x768. The problem is I can't get the HUD keys to appear on the triple head screen only on the DVI screen. If us the MAC control's to swap the Triple Head to Screen 1 and the DVI to Screen 2. Problem tracks, hud keys work on the DVI but not the triple head. Am I missing something?

Thanks!

Guy

[Gian]

I am using triple head, without a problem.... The resolution of 3072x768 just work at 75 Hz, so i was having some work on that, but with the 2400 X 800 or 37XX X 1024 on 60 Hz evrething works fine, give it a try...

Gian

[Guy Conger]

Gian, thanks for the response. I could get the HUD controls to appear when I set the output resolution to 2400x600 (not sure about the refresh rate.) Still no joy when set to 3072x768.

[samsc]

depends on what the graphics card in the mac supports - it might not support that resolution?

not all cards will go that high.

which mac did you use?

[Gian]

I know, me either,... I am very happy with 2400 X 600, and I tested with some monitors what do accept 75 Hz, and works fine on higher resolutions,

Gian

[samsc]

not every graphics card - OR every monitor or combination of monitors supports the maximum allowable resolution at every refresh rate - from the triple head or dual head 2 go devices.

you have to play around to see what comes works and what doesnt.
try setting the monitor outputs, and if the sceen doesnt come back up - its not worked.