I just downloaded and tried to run v4.05.
The software seems to start up fine until it begins to scan for objects and then it causes my primary monitor to go black. The only way out that I can find is to quit. Any ideas?
I just downloaded and tried to run v4.05.
The software seems to start up fine until it begins to scan for objects and then it causes my primary monitor to go black. The only way out that I can find is to quit. Any ideas?
Hi mark ...sound like a resolution or refresh rate monitor problem.
Normally catalyst start resolution at 1024 x 768 at 75 hertz this frequence
not is good for old monitors. put this monitor like secondary (you can set different refresh time after start catalyst) and put on primary monitor new one.
bye.
ROBERTO NOVELLI Resp. Tech. Dept.
Ianiro Aldo srl Company
roberto_novelli@ianiro.com
ianiro_lab@ianiro.com
www.ianiro.com
tel.+39.06.93.10.198
fax+39.06.93.162.162
************************************************** ************************************************** ******************
Le informazioni contenute in questo messaggio e nei suoi allegati sono confidenziali e destinate esclusivamente alla persona o alla societÃÂ* in indirizzo. Ogni inoltro, trasmissione, diffusione o altro uso di queste informazioni a terzi non destinatari sono proibiti salvo espresso consenso di Ianiro. Se ricevete questa comunicazione per errore, contattate il mittente e cancellate le informazioni da ogni computer.
The information contained in this message and in the attachments are confidential and are intended only for the person or entity to which it is addressed. Any review, disclosure, retransmission, dissemination or other use of it is prohibited without the express consent of Ianiro. If you received this in error, please contact the sender and delete the material from any computer.
************************************************** ************************************************** ******************
Something to try:Originally Posted by markjlights
Catalyst has a function that will make it go into full screen mode at the program startup. When at the black screen, hit the "s" key to exit full screen mode on output 1 or the "f" key to exit full screen mode on output 2. If you wish to disable this function for now, the setting is located on the Layer mix options for each output on the GUI.
scan for objects - you mean 3d objects?Originally Posted by markjlights
any more information?