Resolution Reset

[tylerr]

Maybe i am off base here but it sounds like the display settings in the monitors control pannel are set at 1024x768 60hz and the display settings in the catalyst application are set to 1024x768 75hz. Thus when you boot the catalyst it changes and then when you quit it changes back. I would say you should verify that your display setting in the system os are set at what you want for your catalyst output.

Hope that helps,

Tyler

[samsc]

i dont think its my software.

i was trying to eliminate hardware faults before presuming a mistaken presumption from the operator.

richard

[MacStgTek]

Richard-

My apologies for bailing on the thread, got wrapped up in another project.

Ended up sending the machine back to HES, turned out to be a bad video card... And yes all the settings that I had told you were what they actually were.

[samsc]

yes - thanks, very much.

i was asking questions - trying to eliminate the possibility of bad hardware first of all.

it could always have been my software. but you described a problem i have never seen before.