just one server?
you mean when the computer boots up - before catalyst starts?
how many screens?
what monitor are you connected to?
just one server?
you mean when the computer boots up - before catalyst starts?
how many screens?
what monitor are you connected to?
Hey Richard-
Using actually 4 servers, however im jsut having the problem on one server. Im using serveral OptiComm Fiber boxes to transmit the signal to the projectors.
Basically upon the initial install, I set up the preferences of the computer to both be 1024x768 60hz. Then in Catalyst I set both outputs to be 1024x768 60hz. The servers are set up to go to full screen upon launch of program, and the option to set full screen to 1024x768 is also selected.
However each time I power up the program. The resolution output on teh Catalyst Control window resets to 1024x768 75hz 32bit.
Using the standard HES monitor that Catalyst shipped with... using all 8 layers on out output
M
so the resolution doesnt change until you run catalyst?
That is correct. The resolution resets itself. The resolution selection box on the catalyst control window changes itself from 1024x768 60hz to 1024x768 75hz 32bit, each day the operator has to go and change it back to 1024x768 60hz.
M
is the playback frame rate set to 30fps on all machines?
Are you sending DVI or VGA over fibre?
Hugh
Richard-
Sorry... Was on a plane flying to the far east and was without internet access for the past few days.
Yes, the frame rate is set to 30fps on all machines. However the change is only happening on 1 sever, not all 4.
M