Resolution Reset

[MacStgTek]

That is correct. The resolution resets itself. The resolution selection box on the catalyst control window changes itself from 1024x768 60hz to 1024x768 75hz 32bit, each day the operator has to go and change it back to 1024x768 60hz.

M

[samsc]

is the playback frame rate set to 30fps on all machines?

[Spam Butterfly]

Are you sending DVI or VGA over fibre?

Hugh

[MacStgTek]

Richard-

Sorry... Was on a plane flying to the far east and was without internet access for the past few days.

Yes, the frame rate is set to 30fps on all machines. However the change is only happening on 1 sever, not all 4.

M

[MacStgTek]

Hugh-

Using DVI.

M

[samsc]

Richard-

Sorry... Was on a plane flying to the far east and was without internet access for the past few days.

Yes, the frame rate is set to 30fps on all machines. However the change is only happening on 1 sever, not all 4.

M

can you swap the outputs from the machine where this happens - to one that it doesnt happen on? and see if the problem moves.

[tylerr]

Maybe i am off base here but it sounds like the display settings in the monitors control pannel are set at 1024x768 60hz and the display settings in the catalyst application are set to 1024x768 75hz. Thus when you boot the catalyst it changes and then when you quit it changes back. I would say you should verify that your display setting in the system os are set at what you want for your catalyst output.

Hope that helps,

Tyler

[samsc]

i dont think its my software.

i was trying to eliminate hardware faults before presuming a mistaken presumption from the operator.

richard