Page 1 of 2 12 LastLast
Results 1 to 10 of 14

Thread: Resolution Reset

  1. #1

    Resolution Reset

    Having issues with the output Resolution on one of my servers resettng from 1024x768 60hz to 1024x768 75hz everytime it restarts.

    This would be an issue but the fiber conversion unit Im using to send the video down fiber doesnt like the 75hz.

    Any thoughts?

    M

  2. #2
    just one server?

    you mean when the computer boots up - before catalyst starts?
    how many screens?

    what monitor are you connected to?

  3. #3
    Hey Richard-

    Using actually 4 servers, however im jsut having the problem on one server. Im using serveral OptiComm Fiber boxes to transmit the signal to the projectors.

    Basically upon the initial install, I set up the preferences of the computer to both be 1024x768 60hz. Then in Catalyst I set both outputs to be 1024x768 60hz. The servers are set up to go to full screen upon launch of program, and the option to set full screen to 1024x768 is also selected.

    However each time I power up the program. The resolution output on teh Catalyst Control window resets to 1024x768 75hz 32bit.

    Using the standard HES monitor that Catalyst shipped with... using all 8 layers on out output


    M

  4. #4
    so the resolution doesnt change until you run catalyst?

  5. #5
    That is correct. The resolution resets itself. The resolution selection box on the catalyst control window changes itself from 1024x768 60hz to 1024x768 75hz 32bit, each day the operator has to go and change it back to 1024x768 60hz.

    M

  6. #6
    is the playback frame rate set to 30fps on all machines?
    Attached Images Attached Images

  7. #7
    Are you sending DVI or VGA over fibre?

    Hugh

  8. #8
    Richard-

    Sorry... Was on a plane flying to the far east and was without internet access for the past few days.

    Yes, the frame rate is set to 30fps on all machines. However the change is only happening on 1 sever, not all 4.

    M

  9. #9
    Hugh-

    Using DVI.

    M

  10. #10
    Quote Originally Posted by MacStgTek
    Richard-

    Sorry... Was on a plane flying to the far east and was without internet access for the past few days.

    Yes, the frame rate is set to 30fps on all machines. However the change is only happening on 1 sever, not all 4.

    M
    can you swap the outputs from the machine where this happens - to one that it doesnt happen on? and see if the problem moves.

Similar Threads

  1. What resolution is recommended for pixelmad
    By samsc in forum PixelMAD Documentation
    Replies: 4
    Last Post: 10-03-2005, 03:10 PM
  2. Catalyst to DL-1 Resolution
    By texas62 in forum Catalyst Technology questions
    Replies: 6
    Last Post: 01-03-2005, 03:18 PM
  3. 1600x1200 resolution
    By Portal in forum Catalyst Software
    Replies: 22
    Last Post: 26-10-2004, 03:43 PM
  4. higher resolution video cameras
    By samsc in forum Catalyst Technology questions
    Replies: 1
    Last Post: 05-05-2004, 04:08 PM
  5. Resolution vs. Performance
    By Bullen in forum Catalyst Software
    Replies: 3
    Last Post: 22-03-2004, 03:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •