Results 1 to 5 of 5

Thread: DMX not enabled for fixture 1

  1. #1

    DMX not enabled for fixture 1

    In PixelMad f24 the first fixture does not have DMX output enabled (or at least it it does not respond to the colours placed over it and the DMX output at the corresponding addresses stay at zero).

    Also when you select it in the DMX preview window it does not flash orange in the same way as the other fixtures.

    Workaround:

    Start all your patching at the second fixture.

    Ie. If you had 5 54 channel pixel-lines with DMX 1, 55, 109, 163, 217 then

    fixture 2 will have address 1,
    fixture 3 will have address 55

    and so on.

    This was observed in PixelMad8 V2.0 f24.

    Rob Fowler

  2. #2
    thanks rob.

    i must have missed this because on the last major show i did, fixture 1 was a dummy fixture.

  3. #3
    I have found a similar scenario today. However, I found that fixture one will work, in this case a Pixeline, but only if addressed to 55. Channels 1-54 were unusable.

    Ross

  4. #4
    i think there is a hidden fixture somewhere.

  5. #5
    im not seeing this.
    I think there might be some hidden duplicate fixtures?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •