Guys,

I just got off the phone with Jon in Australia.

He is having another go at getting this box working.

From what he described he is seeing non-zero values from the Hog 3 on his PC but the Catalyst is "seeing" the artnet universe (IP address is shown in the artnet status window and Artnet 0 is highlighted blue) but all values are at 0 in the window itself.

It sounds a bit like a problem I was having with the Ether-Lynx box itself recently.

On that occasion I had connection between the box and the Mac itself and PixelMad was outputting DMX. I could modify the image on PixelMad and output DMX to fixtures accordingly but it would not respond to an incoming DMX signal.

It seemed really odd it could "speak" art-net to the Lynx but not "hear" it as it obviously had a good TCP/IP connection.

I could also control PixelMad by connecting a CIB and then use the Lynx to output the DMX to the PixelLines as a workaround.

After trouble shooting with the ArtNet monitor software connected to an ethernet switch on the same network, it turned out to be because I had old firmware on the Ether Lynx box and once upgraded it worked fine.

It was Wayne I spoke to at Artistic so if he recalls the incident he may be able to suggest what differed between the builds.

Richard,

Do you have any ideas what this could have been?

Perhaps it is something that hasn't been implemented on the EtherGate which allows normal Artnet traffic but doesn't talk to Catalyst.

I've suggested Jon post back here with as much info as possible as many heads are better than one.

Rob