please do pdf profile in catalyst -
your problems may be unique to your specific system -
and not seen or reported by anyone else - this is very often the case
and run etrecheck - to see what stuff you got installed
http://etresoft.com/etrecheck
please do pdf profile in catalyst -
your problems may be unique to your specific system -
and not seen or reported by anyone else - this is very often the case
and run etrecheck - to see what stuff you got installed
http://etresoft.com/etrecheck
send both via dropbox
you using mac OS x- very close to initial release of the mac pro 6.1 - 10.9.2 - you not upgrade to last one -10.9.5?
you have firewall in mac os turned on?
thats your network connection issue-
your hp display is using the display port connection - and not responding with any screen EDID- and no valid screen refresh values - ( your catalyst crash at startup was when screen reported no EDID ) - it have a dvi port?
the catalyst safenet dongle driver is crashing all the time- not my software - but 3rd party
try installing latest version-
http://sentinelcustomer.safenet-inc....HL&o=all&t=all
Sentinel HASP/LDK Mac OS X Run-time GUI Installation
-
you mixing display port with dvi-
x4 at 3840x2160 30Hz - with 2560x1600 unknownHz
you not try to use all same outputs at 1920x1080@50Hz ?- i thought this was your show requirement?
like i suggested before? so you get 25/50 on all outputs all at same size and refresh?
i do not believe the x4 can do correct EDID and refresh for exact frequencies at this resolution at either 25Hz or 30Hz
Trully version of mac os is 10.10.2 for now. When install hasp driver used the last one at site but I check if it updated. HP work on 2560*1600@60Hz and in logs tab it discovered properly. I cannot use now dvi because I haven't second converter from mini DP to dual dvi. I use datapath with 4k resolution, because I need 4 separate full HD output, and I have it with 50Hz, as I say earlier datapath can set for each output any refresh rate. (and for trying to test n541 with 5 output I need 5 miniDP - Dual Link DVI wires and usb power hub for this reason, otherwise it wouldn't work)
please install 10.9.5 - do updates for 10.9.2
if you want 4 ( or 5 or 6 ) separate 50hz outputs:
use startech unpowered active adaptors mini display port to dvi- no usb power required - usb power only required for dual link
1080p50 ( and 1080p60 ) is single link for dvi
MDP2DVIMM6BS
http://www.amazon.co.uk/Startech-Dis...i+display+port
there are different colors sexes and lengths