Results 1 to 6 of 6

Thread: Router via Presets

  1. #1

    Router via Presets

    Is there anyway to trigger router inputs/outputs via presets?

  2. #2
    Hi,

    Drag the router config into a cue list. Then in the cue number box type the following: PresetToCuelist=1

    Change the number to match the preset you want to use to trigger. Cue list acts as a lookup table.

    Hope this helps,

    Salvador

  3. #3
    I thought I tried that and but it wouldn't drag. I'll try it again tomorrow.

  4. #4
    I miss spoke in my original post, I was actually talking about the Video Switcher. However, I can't get either the router or the Video Switcher to drag over to the Cuelist. I can get just about every other component on the catalyst control to, but not the Switcher and Router.

    Any ideas?

    Thanks,

  5. #5
    hi, you must press ALT while dragging.

  6. #6
    That did it, thanks!

Similar Threads

  1. Move or cut and paste presets?
    By kdelvo in forum Catalyst Technical support
    Replies: 2
    Last Post: 08-10-2013, 12:19 PM
  2. Importing presets from another showfile
    By kmclights in forum Catalyst Technical support
    Replies: 4
    Last Post: 07-07-2010, 02:12 PM
  3. Moving Presets across machines
    By RyWolf in forum Catalyst Technical support
    Replies: 3
    Last Post: 11-07-2007, 04:19 PM
  4. Editing Presets
    By kmclights in forum Catalyst Software
    Replies: 8
    Last Post: 28-05-2007, 09:59 PM
  5. 'CatCtrl Presets' & 'Mirror Image'
    By RichieS in forum Catalyst Feature requests
    Replies: 3
    Last Post: 17-03-2005, 08:43 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •