TV ONE C2 control

[Barret]

Thanks for the replies -

I realise I seem to be stumbling at the the first block with this.

I've been working through the commands using Isadora as well as quartz as I want to make a little back-up interface to control the c2 machine, and have been it all to work.

However, when I come back into Catalyst to give it a try I can't get the serial connection to work, Catalyst can see the device but says it 'can't open' the port (see attached image). I've tried a full reboot, making sure nothing else is trying to use the connection
I'm using a Keyspan USA-19HS - I've tried both m329 and m364 builds. On two operating systems 10.6 & 10.8
- Any thoughts would be appreciated