Custom ASCI UDP/TCP/IP commands send

[michalp8]

Hi, Can you add (or modify custom serial module) to allow send ASCI commands to switchers etc.

[Mr_P]

write the asci commands in " " quotes

Hex commands go in [] square brackets

[michalp8]

But how to send it via LAN network to IPaddresort? I want to send ASCI comands to Analogway ORC-50 via TCP/IP or UDP protocol.

[Mr_P]

{EDITED TO ADD MORE DETAILS...}

Create a TCPIP port in serial settings:


You then have to restart catalyst for the TCPIP ports to appear

Then insert the IP address and port for the device and choose UPD or TCP
(example above shows 4 devices)

Select the TCPIP for each serial control device :



Then write your command:



(This is a command written in HEXfor a Kramer matrix to switch 4 inputs to 4 ouputs)
Each HEX command is in [square brackets]



(This is a command written in TEXT and HEX for a Kramer matrix to switch 4 inputs to 4 ouputs)

Each TEXT command is in "QUOTES" and the carriage return for the command is in HEX [0d]

Let me know if you need more info -

PLEASE NOTE - THIS IS AN EXAMPLE - NOT THE ACTUAL SETTING YOU WILL NEED...

(unfortunately I don't know the commands for the matrix you mention - do check the manufacturers manuals for details...)

S

[samsc]

But how to send it via LAN network to IPaddresort? I want to send ASCI comands to Analogway ORC-50 via TCP/IP or UDP protocol.

what are the commands you need to send?

[michalp8]

Mainly commands to load preprogramed presets in ORC-50, but I will check taht tomorrow and I think I can do that.

[Mr_P]

just had a look at the website:

see serial commands PDF for details:
http://www.analogway.com/downloads/u...0_Protocol.pdf

Example:
To Load the Preset Memory #10

command to insert in to catalyst would be:
"10PL"


S