HD-SDI input not working - Help!

[David Monguet]

Hi,
I just copied this from another post; PE1 only works in SLOT3, be sure that is correct in your machine.
Hope this helps,

David.

"in order to have the best performance of phoenix working on
OS 10.6.x snow leopard mac pro's 5.1 insert Phoenix card
on SLOT 3 only.

Phoenix PE4 working fine on any slot of the mother board.
Phoenix PE1 working fine only slot 3 of the mother board.

Put your Phoenix on SLOT 3.

Check info mac/more information/PCIe/slot read if driver is installed,
you need reinstall driver if you move phoenix in different slot
(only one time).


if serial number your Phoenix starting by 5xxx please contact
Active Silicon Support,probably your phoenix need reflash at
last firmware version to working at the best.

for sure at moment you must work at 32 bit


Let we know.....


ROBERTO NOVELLI __________________
----------------------------------------
dotations for Catalyst test in my Black Room
(Richard seen)

mac pro 8 cpu's 12 Gb Ram
Cata-lynx Artnet 2 univ.
Luminex node 2 wifi Artnet+dmx at 5 Ghtz
Pepeoni Rodin 2
Mtron 64 Gb
1 Terabyte Raid
LFG4
Decklink Extreme HD
TH2go Dig.+TH2go Anal.
Datapath VQS01
3 x monitor DVI/vga
3 x DL1 (lx 55 inside)
Whole hog 3
Hog pc wifi connected
Audio 5.1 surround

[ljb2of3]

It is in slot 3, or it was the last time I actually looked inside the case... so I'm pretty sure it is still there.

I also know the kernel is booting in 32 bit mode, and the drivers are installed.

From everything I can find / see in catalyst, the card is working, it just doesn't seem to like the signal coming in. Are there different HD-SDI standards, or is HD-SDI always just HD-SDI?