720 x 480 resolution / grandMA2

[Mr_P]

Set the Image PRO EDID to 720x480 and it should pop up in display prefs.

However - you should really see what resolution your LED Wall processor will accept...
- Ditch the image pro and connect directy to it at an acceptable native resolution (1024x768 / 800x600 or simlar)
- then use a mix window in catalyst at 720x480 and run your content 1:1
- ensure that your LED processor is set to 1:1 scaling too

Image Pros are so over-used... when simply figuring out the best native resolutions works much better. Theres no point in scaling up, then back down

(The exception to this if if you have to convert to SDI or similar)

let me know if you need more help

S

[fatmiko]

Hello Simon --

Thanks for your reply. Got the image pro to show up at 720 - thanks!

Ok - So I'm being told that the Stealth processors really want to see 1024x768. We're using the image pro at FOH to change to SDI to send to the stage.

This is my first time playing with mix windows so I think I can get to where I need to based on your advice. But to push it a bit further - we are also using a couple projectors to project onto the PA. I've been worried about signal flow to them, but with this discovery of mix windows(i know, new guy), perhaps I can put up 3 mix windows on the second output (2 for the projectors, with the 720 mix in the middle for the walls. I'm capable of sending 1920 out of the mac to the folsom, and letting the video guys do whatever they do with it. Does this sound like a good plan?

Thanks again.

Mike Cooper
+1.573.450.2150