M329+FX4000 quadro problem

[fabiopagano]

Also with only one triple head Displayport same defect, When catalyst go in full screen mode black screen (no video input) I need 6 out at 1280x1024 to drive a 6 mm pitch LED screen measuring 3360x1360 total resolution size mix 1120x680 x 6
some ideas for fix this ?thanks to all

[samsc]

Also with only one triple head Displayport same defect, When catalyst go in full screen mode black screen (no video input) I need 6 out at 1280x1024 to drive a 6 mm pitch LED screen measuring 3360x1360 total resolution size mix 1120x680 x 6
some ideas for fix this ?thanks to all

is this for the display port model or the other one?
this means you are doing something the triple head and graphics card dont want to do

-

what refresh rate are you set to?

[fabiopagano]

refresh rate is 60 hz resolution is 3840x1024,3072x768, same defect, triple head display port on out one of quadro 4000 (display port )

[samsc]

refresh rate is 60 hz resolution is 3840x1024,3072x768, same defect, triple head display port on out one of quadro 4000 (display port )

and the other output? the dvi output?
does that work at this resolution?

--

start at the lowest possible output size and work up
dont start at highest size and work down

[fabiopagano]

second out connected to triple head DVI at 3840 x1024 is ok ,primary out connected to triple head Dysplay port at 3840 x 1024 is ok but only when catalyst not is in full sceen mode, also whit resolution more little i have same issue,the triple head display port do not work stable

[samsc]

second out connected to triple head DVI at 3840 x1024 is ok ,primary out connected to triple head Dysplay port at 3840 x 1024 is ok but only when catalyst not is in full sceen mode, also whit resolution more little i have same issue,the triple head display port do not work stable

what low resolutions you try? -with only DP connected

[fabiopagano]

i have tray whit 2400x 600,3072x768,3840x1024. Display port whitout triple head work ,i have try also triple head dvi whit adapter active displayport to dvi dual link , but resolution max for primary out is 2400x 600 second machine have 1 monitor for preview and 1 triple head DVI AT 3840X1024 for 3 screen and work well.I dont wont cut the big screen led 3660x1360 on two machine .

[SourceChild]

...I need 6 out at 1280x1024 to drive a 6 mm pitch LED screen measuring 3360x1360 total resolution size mix 1120x680 x 6...

If I understand you correctly, you have 6 processors feeding 6 walls that are configured in a 3x2 arrangement...

I just created a test piece of content 3360x1360. I used my 2010 12-core mac pro running Catalyst with 2 RAID0 SSDs outputing on a quatro 4800.

I was only able to run 1 layer of content without frames dropping.

I did however split the piece into two pieces at half size (3360x680) and was able to run them both in perfect sync on 2 2008 mac pros.

If you do the same thing then you'll be fine.

Oh and please share more about the wall. I am impressed by a wall that is 20x8 meters at that high a that resolution.