I asked Steve to update the lib.
In the webserver I cant find the DMX Values for those new modes
Any idea where to look or where I can find an actual DMX Chart?
I asked Steve to update the lib.
In the webserver I cant find the DMX Values for those new modes
Any idea where to look or where I can find an actual DMX Chart?
Hi Richard,
I am working with Catalyst m329 in GrandMA console, I created some libraries to work with Mix Type, etc.
I am having the following problem, I pass in more parameters but I put this as an example.
MIX Type
Ch6 MIX Screen Left - 16 bit
NO Change 0
Position 1 to 30000.
It often happens that if we have the Encoder in coarse mode and spent a 1, 2 etc and returning to 0 (1 step in coarse encoder 256 steps in fine) is not well reflected the movement, since a value 0 corresponds to no change .
Thus the mix is half display when they should be left completely.
This happens with all the parameters that have values of 0 and NO change.
Any suggestions?
Thanks
E. Cueto
its absolutely essential to have a 'no change value'
otherwise you the poor end user -
have to program every single value to do something - to be a default- even when you dont need it-
you might just want to set one value in the mix setup -
but without a no change - you cant do this
Would you please explain a little more the concept of -No change-.
Referred to Catalyst.
When I turn off the lamp from a moving light, select -Lamp OFF- and that if the default parameter of the lamp does -not change value-
If I release the parameters of the -Clear ALL- lamp will turn back on past time.
Here that I understand the value of "No change"
But do not know, to transfer this concept to a Catalyst Mixer.
Sorry for my ignorance.