Catalyst v4.4 m329

[escueto]

hi all
control through the window of catalyst mixer, I can get negative values for Screen 1 and 2, TOP, LEFT, but since arnet NOT possible?
Mix Type, channels 4,6, 12 and 14.

A greeting

E. Cueto

[NevBull]

Hi there

not sure why you need to move the mix off of the screen? If you need to move content off, just use the Offset value instead?

Nev.

[escueto]

I'm working on the libraries for Ma
It was just a technical question.
thanks

[mlorenz]

Hi there

not sure why you need to move the mix off of the screen? If you need to move content off, just use the Offset value instead?

Nev.

I used it in touring situations, 4 LED-Circles, each used 3 mixes (1 covering 120°), in smaller venues where we only could setup half-circles, it was much easier to shift the mixes off the screen then to redo the programming.
I was necessary or easier to do it like this in combination with the mapping-controller for the LED-Screen (which was kind of "stupid")

[escueto]

its absolutely essential to have a 'no change value'
otherwise you the poor end user -
have to program every single value to do something - to be a default- even when you dont need it-

you might just want to set one value in the mix setup -
but without a no change - you cant do this

Would you please explain a little more the concept of -No change-.
Referred to Catalyst.
When I turn off the lamp from a moving light, select -Lamp OFF- and that if the default parameter of the lamp does -not change value-
If I release the parameters of the -Clear ALL- lamp will turn back on past time.
Here that I understand the value of "No change"

But do not know, to transfer this concept to a Catalyst Mixer.

Sorry for my ignorance.

[samsc]

Would you please explain a little more the concept of -No change-.
Referred to Catalyst.
When I turn off the lamp from a moving light, select -Lamp OFF- and that if the default parameter of the lamp does -not change value-
If I release the parameters of the -Clear ALL- lamp will turn back on past time.
Here that I understand the value of "No change"

But do not know, to transfer this concept to a Catalyst Mixer.

Sorry for my ignorance.

does not change values programmed already in catalyst gui


catalyst is not a lamp - it has its own cue lists and presets - and values

[mlorenz]

Is there a fixture Update to add all the new play modes to the Road Hog Full Boar. I can only find 2 of the audio play modes and I know there are more now.
RHFB 3.1.7

*nevermind- it takes two buttons*
Ryan

Which version did you use in your RHFB?
HighEnd oder Catalyst as manufacturer?

You must use Catalyst, then it should all be fine.

I was in contact with Steve from Highend who takes care of the libs.
I did some screenshots of the actual values from the pulldown menu and send those to him. He checked all values for m329 and they should all be fine he told me.