Also check that the refresh rate is correct. Many LED screens will only display at 60hz and not the 75hz that Catalyst defaults to.
Cheers
Toby Harding
Also check that the refresh rate is correct. Many LED screens will only display at 60hz and not the 75hz that Catalyst defaults to.
Cheers
Toby Harding
hello
thanks for your answer, i have install the matrox soft and i 'm using the OUT2 of ATI at 3072x768 refresh 60Hz and then on the triple head i have 3 X 1024x768 at 60Hz, all work fine with monitor DVI but when i change one monitor with a LED PANEL "starframe" with a STARGATE, then no signal come on this OUTPUT.
I would like to install SwitshResX to force refresh and resolution of the OUTPUT. but i don't know the good info of the EDID of the led panel...
I think the big problem is the Stargate witch control LED PANEL and the "EDID" of them...
no one use this led panel ?
thanks averybody
Yves