Results 1 to 6 of 6

Thread: Artnet Issues

Hybrid View

  1. #1
    That's indead a good question.
    For being honest, I can't even remember how it was. There was the Special Firmware to download on the Website.

    If I remember right ELC is a very small company so contacting the distributor in your country is often much faster than contacting them directly.

    But, If you might have a look which firmware you're running I can check in my node if this is the latest one.

    Best

    Rolf
    www.chaoscenter.net

  2. node 8

    I just used a node 8 today, set ip address and it worked right out of box.

    Randy

Similar Threads

  1. Continous Artnet streaming...
    By OlliR in forum Software support
    Replies: 19
    Last Post: 16-02-2008, 06:22 AM
  2. Load Bars / Artnet Issue
    By NevBull in forum Catalyst Technical support
    Replies: 3
    Last Post: 04-08-2007, 09:20 PM
  3. Catalyst Artnet Input...
    By OlliR in forum Bug reports
    Replies: 4
    Last Post: 26-07-2006, 07:18 PM
  4. Does f45 need dongle or activation for Artnet output?
    By OlliR in forum Software support
    Replies: 1
    Last Post: 10-02-2006, 07:02 PM
  5. Enttec ethergate artnet connection issue
    By JonT in forum Catalyst Software
    Replies: 14
    Last Post: 31-03-2005, 08:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •