New manual

[samsc]

i dont write the manuals.
i dont get a chance to check them either.

i make the software as self-documenting as i can.
then highend gets to do whatever.

---

you dont need to access + 1hr or any other hour offset with mtc.
hours are just ignored.
you can use positive and negative offsets from this using the in and out points.

the maximum length of movie you can have is around 43 minutes because of the limitations of 16 bit dmx.

[Improve]

Is it then so that the offset with in/outframe is in frames, so with 25 fps we have to calculate for 1 minute, 1500 frames...

But what if I have a kind of preshow, before a movie starts. I like the movie to start at 1hr, 0min,0sec.... and before that, at 55min,20sec orso i want to start a few clips and other things.....

Does Catalyst handles this automaticaly in the right way then, since you say that movie length is limited to around 43 minutes.....??????

[samsc]

i intended that if you needed 55 minutes for the time code you use a negative offset of 5 minutes - 7500 frames.

I havent tested this recently.
It may or may not have issues.

----

'Catalyst' or quicktime is not limited to 43 minutes --- 16 bit dmx can only represent up to 65535 frames which is around 43 minutes - less at 30 fps.

[Improve]

OK...

I will try this and see what happens....

I might come back to you in some time for additional info....

Maybe you will be at PLASA?? We will be there on monday and tuesday....

[samsc]

please check. its a very obscure but sometimes important function which not many people ever get to check.

---

plasa? maybe