Catalyst v4.1 m152

[samsc]

Image Pro control

Recent software builds after around m145 - have included my experimental direct folsom imagepro control panel

http://video.folsom.com/products/?in...70327722_18404

I have written a control panel to read and write parameters directly to the imagepro over ethernet-

You can read the settings on all 4 inputs.
Switch between inputs.
Enter exact zoom and scale positions.

To use the device- you need to set the imagepro to use a static ip address
To enter the address of the imagepro into catalyst - you click were it says N/A - then type in the address of the device-
When you click OK they should start talking to each other.