Catalyst v4.1 m152

[tharding]

There is still the issue of the size jumping if you are trying to resize the largest size mix.

My scenario is that we are using a Spyder to spread a single output of a 1900xt at 1920 x 1600 over 2 projectors. Ideally I want the mix to be 1920 x 612 pixels. If I size the mix to 1920 x 1080 as per the menu in Mix options it goes to that size no problem. But if I want to drag the corner up to get my 612 size the width snaps to 1710 pixels.

I can get around this with cropping and positioning on the Spyder but I would really like to have it on the Catalyst so I can preview the image at the source and see that my sizing is all correct and that my custom artwork looks as it should.

Cheers

Toby

[samsc]

There is still the issue of the size jumping if you are trying to resize the largest size mix.

My scenario is that we are using a Spyder to spread a single output of a 1900xt at 1920 x 1600 over 2 projectors. Ideally I want the mix to be 1920 x 612 pixels. If I size the mix to 1920 x 1080 as per the menu in Mix options it goes to that size no problem. But if I want to drag the corner up to get my 612 size the width snaps to 1710 pixels.

I can get around this with cropping and positioning on the Spyder but I would really like to have it on the Catalyst so I can preview the image at the source and see that my sizing is all correct and that my custom artwork looks as it should.

Cheers

Toby

the limit is 1680 + a little bit-
im really concerned about performance on older machines.
this really has a serious impact on graphics cards.

[samsc]

Image Pro control

Recent software builds after around m145 - have included my experimental direct folsom imagepro control panel

http://video.folsom.com/products/?in...70327722_18404

I have written a control panel to read and write parameters directly to the imagepro over ethernet-

You can read the settings on all 4 inputs.
Switch between inputs.
Enter exact zoom and scale positions.

To use the device- you need to set the imagepro to use a static ip address
To enter the address of the imagepro into catalyst - you click were it says N/A - then type in the address of the device-
When you click OK they should start talking to each other.