Hi Roberto / Richard,
I may be missing something here, however, when I go to preference - video input, the box enable lfg direct api is enabled. Where do I go from here?
best regards
Ian
Hi Roberto / Richard,
I may be missing something here, however, when I go to preference - video input, the box enable lfg direct api is enabled. Where do I go from here?
best regards
Ian
some some reason it's disable .Originally Posted by Ianp
PREF VideoInput/LFGDirectEnable -- OFF
PREF VideoInput/LFGBlueCut -- OFF
. this is not helpy in this case , but I suggest to run 4,6m111 in a new folder , do not run it in the same folder where older versions preference files was stored in .
Hi,
just tried the sw in a new folder and it still does not work.
Regards
Ian
Sorry , I did a mistake , I was talking about something elseOriginally Posted by Ianp
E
Hi Richard,
AS have now provided updated drivers which work (finally!!).
Thanks fot the help and I have attached the link below
http://www.activesilicon.co.uk/downl...-v02_00_00.dmg
Many thanks again
Ian
where are you?
Hi Richard,
Still not having much luck in getting this to work. I have again re-installed the drivers you sent after deleting those incorrectly installed. Do you know what files should be installed by your drivers?
Thanks
Ian
Richard,
I suspect I may have some hardware issues here. I have just downloaded security spy sw from active silicon and that does not recognise the card at all. Unfortunately I have had to re-install their drivers but I will be able to uninstall them.
What does work is the canopus ADVC110 unit with both Catalyst and Security Spy software. I will try reconfiguring the bus and see if that helps, otherwise I will talk to AS tomorrow.
Any thoughts?
Ian
for security spy to work - as you are using an intel machine - you need the universal beta version of the Active silicon drivers for quicktime.
you initially installed the ppc only version of these drivers.
This is version 1.5
You needed v1.6 universal for this to work - do you have this?