6 live video inputs. What hardware?

[roberto_novelli]

you can see on your profile this:


DR (64.388)-** End Open Prefs - 58 3a
DR (64.401) -** Open Prefs SG 1- 59
LFG Direct mode not enabled

your direct drivers for LFG4 is not enable....
you can do it on CATALYST preferences

and in the config panel put flag on LFG4 direct driver.

this fix your problem.
bye.


Roberto Novelli HighEndSystem dealer for ITALY

Product Manager & Technical Support
roberto_novelli@ianiro.com
IANIRO ALDO srl.

helpdesk : ianiro@ianiro.com
http://www.ianiro.com
Sede principale/Head Office : Via Ragusa, 5
Logistica/Logistics : Via Ragusa, 3
00040 Pavona (Roma)- ITALY
+39 06 9310198 ra tel
+39 06 93162162 fax

[Ianp]

Hi Roberto / Richard,

I may be missing something here, however, when I go to preference - video input, the box enable lfg direct api is enabled. Where do I go from here?

best regards

Ian

[emilianomorgia]

Hi Roberto / Richard,

I may be missing something here, however, when I go to preference - video input, the box enable lfg direct api is enabled. Where do I go from here?

best regards

Ian

some some reason it's disable .

PREF VideoInput/LFGDirectEnable -- OFF
PREF VideoInput/LFGBlueCut -- OFF

. this is not helpy in this case , but I suggest to run 4,6m111 in a new folder , do not run it in the same folder where older versions preference files was stored in .

[Ianp]

Hi,

just tried the sw in a new folder and it still does not work.

Regards

Ian

[emilianomorgia]

Hi,

just tried the sw in a new folder and it still does not work.

Regards

Ian

Sorry , I did a mistake , I was talking about something else

E

[Ianp]

Hi Richard,

AS have now provided updated drivers which work (finally!!).

Thanks fot the help and I have attached the link below

http://www.activesilicon.co.uk/downl...-v02_00_00.dmg

Many thanks again

Ian

[samsc]

where are you?

[Ianp]

Hi Richard,

Still not having much luck in getting this to work. I have again re-installed the drivers you sent after deleting those incorrectly installed. Do you know what files should be installed by your drivers?

Thanks

Ian

[Ianp]

Richard,

I suspect I may have some hardware issues here. I have just downloaded security spy sw from active silicon and that does not recognise the card at all. Unfortunately I have had to re-install their drivers but I will be able to uninstall them.

What does work is the canopus ADVC110 unit with both Catalyst and Security Spy software. I will try reconfiguring the bus and see if that helps, otherwise I will talk to AS tomorrow.

Any thoughts?

Ian