In SAMSC you could specify an X or Y variable by putting x or y into a custom serial string.
I see the x and y columns in the cuelist for a serial command, but can't seem to click to edit them.
Ideas?
Printable View
In SAMSC you could specify an X or Y variable by putting x or y into a custom serial string.
I see the x and y columns in the cuelist for a serial command, but can't seem to click to edit them.
Ideas?
Are you referring to the ability to edit the X and Y variable of a layer or mix?
Editing the X and Y variable.
In SAMSC I had a serial string where X specified the Macro Number I wanted to trigger via MSC.
yes - im not sure where this went- i think its for the cue list.Quote:
Originally Posted by jabadger
i think i removed it for catalyst - because it was a little complex.
Awe. Ok. I used that quite a bit.
i took them out because my catalyst users never did anything that complex -
you need them back?
richard
It would be helpful. I would use them to trigger a bunch of macros on a Virt - I have in the past, had more than the 12 strings that are available in the serial setup.