Printable View
Has anyone successfully communicated with the Kramer 6x6 DVI to switch presets using the custom serial sends? I left work this evening thinking this will probably be harder than it should be, so any pointers in the vague correct direction would be greatly appreciated.
Cheers
Andy
UPDATE:
That was a little easier than anticipated, the hardest part was finding the correct software to set the ethernet:
1: Get the software here: http://www.kramerelectronics.com/sup...ad.asp?f=30115
2: PC only, connect to your device via a ethernet hub/switch
3: Set up a custom serial device with TCP Output, the ipi of the unit to communicate with and the default port is generally 5000 if you haven't changed it.
3: The stings to send are the same as the 232 commands, e.g as follows:
Recall Preset 1
[04818081]
Recall Preset 2
[04828081]
Recall Preset 3
[04838081]
And on and on, for induvidual patching in and out see the Kramer documentation.
http://www.kramerelectronics.com/dow...00_rev0_51.pdf
Page 10 is handy.
Cheers
Andy