View Full Version : Router via Presets
clussier
29-10-2014, 07:22 PM
Is there anyway to trigger router inputs/outputs via presets?
Salvador
30-10-2014, 12:14 AM
Hi,
Drag the router config into a cue list. Then in the cue number box type the following: PresetToCuelist=1
Change the number to match the preset you want to use to trigger. Cue list acts as a lookup table.
Hope this helps,
Salvador
clussier
30-10-2014, 12:23 AM
I thought I tried that and but it wouldn't drag. I'll try it again tomorrow.
clussier
30-10-2014, 03:26 PM
I miss spoke in my original post, I was actually talking about the Video Switcher. However, I can't get either the router or the Video Switcher to drag over to the Cuelist. I can get just about every other component on the catalyst control to, but not the Switcher and Router.
Any ideas?
Thanks,
PascalVittoz
30-10-2014, 03:50 PM
hi, you must press ALT while dragging.
clussier
30-10-2014, 07:25 PM
That did it, thanks!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.