Router via Presets

[clussier]

Is there anyway to trigger router inputs/outputs via presets?

[Salvador]

Hi,

Drag the router config into a cue list. Then in the cue number box type the following: PresetToCuelist=1

Change the number to match the preset you want to use to trigger. Cue list acts as a lookup table.

Hope this helps,

Salvador

[clussier]

I thought I tried that and but it wouldn't drag. I'll try it again tomorrow.

[clussier]

I miss spoke in my original post, I was actually talking about the Video Switcher. However, I can't get either the router or the Video Switcher to drag over to the Cuelist. I can get just about every other component on the catalyst control to, but not the Switcher and Router.

Any ideas?

Thanks,

[PascalVittoz]

hi, you must press ALT while dragging.

[clussier]

That did it, thanks!