PDA

View Full Version : Panasonic Lamp Commands



Trench117
07-02-2014, 04:14 PM
Has anyone had any success with lamping projectors on and off over http? Shutter commands are working fine using the serial device control in catalyst but I am struggling to find a working address for lamp commands.

Cheers,

D

kiwi
09-02-2014, 06:25 AM
Yes. It works well.
same process as opening and closing the shutter

commands are;
lamp on
http://user1:panasonic@projaddress/cgi-bin/proj_ctl.cgi?key=pow_on&lang=e&osd=on

lamp off
http://user1:panasonic@projaddress/cgi-bin/proj_ctl.cgi?key=pow_off&lang=e&osd=on

shutter open
http://user1:panasonic@projaddress/cgi-bin/proj_ctl.cgi?key=shutter_off&lang=e&osd=on

shutter close
http://user1:panasonic@projaddress/cgi-bin/proj_ctl.cgi?key=shutter_on&lang=e&osd=on

just change the 'projaddress' to your projectors IP address.
set the output of the custom serial device to "no output"

AndyCoates
17-02-2014, 08:18 AM
I did this for a friend a while ago and have been meaning to upload for a while. Should work with the majority of flavours of Panasonic's.

Cheers

Andy