PDA

View Full Version : Serial Variables



jabadger
27-01-2009, 11:59 PM
In SAMSC you could specify an X or Y variable by putting x or y into a custom serial string.

I see the x and y columns in the cuelist for a serial command, but can't seem to click to edit them.

Ideas?

SourceChild
05-02-2009, 10:43 AM
Are you referring to the ability to edit the X and Y variable of a layer or mix?

jabadger
07-02-2009, 06:32 PM
Editing the X and Y variable.

In SAMSC I had a serial string where X specified the Macro Number I wanted to trigger via MSC.

samsc
07-02-2009, 11:30 PM
Editing the X and Y variable.

In SAMSC I had a serial string where X specified the Macro Number I wanted to trigger via MSC.

yes - im not sure where this went- i think its for the cue list.
i think i removed it for catalyst - because it was a little complex.

jabadger
09-02-2009, 05:22 PM
Awe. Ok. I used that quite a bit.

samsc
09-02-2009, 10:50 PM
i took them out because my catalyst users never did anything that complex -
you need them back?

richard

jabadger
10-02-2009, 10:44 PM
It would be helpful. I would use them to trigger a bunch of macros on a Virt - I have in the past, had more than the 12 strings that are available in the serial setup.