View Full Version : rs 232
ajmaudio
08-10-2008, 04:32 AM
using a videotek 12 channel router/switcher to switch sources into the HD Extreme card in new machine... it emulates a grass valley device as far as control parameters via serial... Leitch is also part of this group I beleive.. does anyone know if the Leitch profiles built into catalyst will work on these devices.. I wont have the switcher on hand for a bit and wanna get this squared away before tour starts.. thanks
ajmaudio
08-10-2008, 04:44 AM
scratch that... I thought there was a 12 channel switcher in there but I dont see one.. .the problem I am having is that I have the grass valley protocols manual ... which needles to say covers devices way more advanced than the unit I will be using... and I cannot clearly see how to construct the control strings.... it would appear that they are far more complex than any strings I have seen for other devices.. any help or insight would be appreciated
samsc
08-10-2008, 05:16 AM
scratch that... I thought there was a 12 channel switcher in there but I dont see one.. .the problem I am having is that I have the grass valley protocols manual ... which needles to say covers devices way more advanced than the unit I will be using... and I cannot clearly see how to construct the control strings.... it would appear that they are far more complex than any strings I have seen for other devices.. any help or insight would be appreciated
just use 16 channel switcher in catalyst - the way switcher protocols work it does the right thing-
you need to post some of the control strings - i dont know what they are.
normally its a simple connect like command - connect output 1 to input 2 ...
ajmaudio
08-10-2008, 06:38 AM
well thats the problem.. it appears that the device cant just take a string whenever.. u have to initiate sessions, calculate checksums etc etc... the device is a videotek rs-12a. I thought u had to use the serial control device in catalyst to do this btw???
samsc
08-10-2008, 08:26 AM
well thats the problem.. it appears that the device cant just take a string whenever.. u have to initiate sessions, calculate checksums etc etc... the device is a videotek rs-12a. I thought u had to use the serial control device in catalyst to do this btw???
thats complex! for a switcher.
i have never seen or used these switchers-
i have done a control panel for kramer, extron, and some others- they are much easier-
----
if it uses a transaction protocol - i have to write software - and i need the device-
ajmaudio
08-10-2008, 05:46 PM
it looks like their may be a dumbed down version of the protocol that will work on this device... I hope so! I'll keep u posted just in case it comes in handy for someone in the future.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.